溶胶-凝胶制备技术与新型催化材料Ⅲ.溶胶粒子表面修饰方法制备催化膜

提出用溶胶粒子表面修饰方法，结合溶胶凝胶技术制备无机催化膜．该方法的基本原理是利用合适的金属配合物在胶粒表面的吸附作用，经溶胶凝胶过程，将活性组分结合到无机膜中．实验测定结果表明：（ＮｉＥＤＴＡ）２－，ＶＯ－３，ＭｏＯ２－４，（Ｐｄ（ＮＨ３）４）２＋，ＰｄＣｌ２－４，ＰｔＣｌ２－６和ＲｈＣｌ３－６可用来修饰ＡｌＯＯＨ溶胶．以Ｐｄ／γＡｌ２Ｏ３催化膜的制备为例，经三次溶胶凝胶过程，可制得无裂缺的厚度为９μｍ的Ｐｄ／γＡｌ２Ｏ３催化膜，膜材料的平均孔直径为６ｎｍ，Ｐｄ被均匀地分布在膜的顶层，其平均粒径为２３ｎｍ．     

Selectivity changes towards steroids in packed column supercritical fluid chromatography (SFC) induced by temperature and pressure variation

Summary Pressure/temperature variation in SFC was shown to influence selectivity towards steroids. Major changes were observed for polar column packings compared to non-polar packings and variation of the amount of modifier showed that this is valid over the whole investigated range. The effect is underlined by a fall in resolution in the low density range (low pressure/high temperature) for polar stationary phases and appears to be significantly larger than for non-polar phases. Major selectivity shifts induced by variation of the physical properties of the mobile phase are considered to be due to the greater effect of polar modifiers on the nature of polar stationary phases than on non-polar phases.     

Linearization of column responses by correlation chromatography. Separation improvement and reduction of undesired adsorption effects

Summary Experiments and simulations prove that correlation chromatography can greatly reduce the disadvantage of a non-linear response of the chromatographic column. A factor that has been accepted as being an important source of error in correlation or multiplex chromatography, has been shown not to be. Separations affected, improve dramatically when correlation chromatography is used, and a substantial amount of correlation noise only arises when there is a large difference in separation between a conventional chromatogram and a correlogram.A model has been developed for simulating these nonlinearities. It is shown that, especially for correlation chromatography, the simulation results match the practical measurements very well.     

压力淬火过程中锗的相结构研究

 应用高压原位差热方法，直接测量了压力下锗的固化参数─—固化温度与过冷度。高压差热信号表明，当压力大于3 GPa时，锗在凝固过程中可能发生结构相变。X射线结构分析表明，在最终的样品中除GeⅠ相外，还形成GeⅢ相和GeⅣ相。     

Phasenbeziehungen und Natriumionenleitung im quasi-binären System Na2SiF6/Na3AlF6

Phase Relations and Sodium Ion Conductivity within the Quasi-binary System Na₂SiF₆/Na₂AIF₆ . The phase diagram of the Na₂SiF₆/Na₃AlF₆ system has been determined by means of x-ray powder diffraction, thermal analysis and conductivity measurements in the sub-solidus region. Na₃AlF₆ accomodates up to 73 mol.-% Na₂SiF₆ maintaining the crystal structure type. The sodium ion conductivity increases by about five orders of magnitude upon doping Na₃AlF₆ with Na₂SiF₆.     

Schwinger boson mapping of SO(8) fermion model

The Schwinger representation of the SO(8) fermion pair algebra in terms ofd and quasispin vector (u, s, v) bosons is used in deriving a microscopic boson coherent state having both particle-hole and pair excitations. The coherent state is the exact boson image of the HFB variational solution. We can study the shape phase transition and pairing behaviour of the nuclear ground states using the coherent states.     

Ti_(1-x)(Hf_(0·919)Zr_(0·08))_xNiSn的制备及热电性能

采用固相反应法合成了单相的Ti_(1-x)(Hf_(0·919)Zr_(0·08))_xNiSn(x=0·00—0·15),并用放电等离子烧结方法制备出密实块体材料.研究了Hf和Zr同时在Ti位上的等电子合金化对Ti基半Heusler化合物热电性能的影响规律.结果表明:少量的Hf和微量的Zr在Ti位上的等电子合金化,显著地降低了体系的热导率κ,同时显著地提高了体系的Seebeck系数α.组成为Ti_(1-x)(Hf_(0·919)Zr_(0·08))_(0.15)NiSn的试样室温热导率为3·72W·m-1K-1,在700K时ZT值达到最大为0·56.与三元TiNiSn相比,在相同温度下ZT值的提高率为190%—310%.     

Ni(111)表面一氧化碳和氢共吸附的密度泛函理论研究

本文用密度泛函理论(DFT)的总能计算研究了一氧化碳和氢原子在Ni(111)表面上p(2×2)共吸附系统的原子结构和电子态，结果表明CO和H原子分别被吸附于两个对角p(1×1)元胞的hcp和fcc位置.以氢分子和CO分子作为能量参考点，总吸附能为2.81 eV，相应的共吸附表面功函数φ为6.28 eV.计算得到的C—O，C—Ni和H—Ni的键长分别是1.19?, 1.96?和 1.71?，并且CO分子以C原子处于hcp的谷位与金属衬底原子结合.衬底Ni(111)的最外两层的晶面间距在吸附后的相对变化分别是 关键词： Fisher-Tropsch反应 催化作用 Ni(111) p(2×2)/(CO+H) 共吸附     

量子相变

量子相变是一种发生在绝对零度,由量子涨落而非热涨落导致的相变现象,满足著名的海森堡不确定关系。通过零温量子临界点的研究,可获知物质系统更广泛范围的行为,包括稀土磁性绝缘体,高温超导体和二维电子气体等。     

直接置换法制备包覆型纳米铜-银双金属粉末

 以AgNO₃为主盐，采用直接置换法初步制备了包覆型纳米铜-银双金属粉末，分析了工艺条件对包覆效果的影响，并用透射电子显微镜、X射线能量色散谱仪和X射线衍射仪进行了表征。实验结果表明：纳米铜-银双金属粉末为包覆型结构，平均粒径约70 nm，分散性较好，表面银的原子分数达到74.28%。在洗涤过程中加入一定量的保护剂，有效解决了纳米铜粉的氧化问题。